SMALL BATCH RESIN MIXER is the easiest way to automatically mix small batches of thick liquids and needs NO CLEANUP.

Our muzzle brakes are an industry leader! Our Gen 2 is a two-piece design that allows the shooter to quickly install or remove their muzzle brake for whatever reason. Say goodbye to crush washers, peel washers, or the need for a professional installation. Your hands and a crescent wrench are all that is needed. We offer these brakes in stainless steel or a nitride black finish.

THE GEN 2 LITTLE BASTARD IS BORED TO ACCOMMODATE CALIBERS .308" OR SMALLER SUCH AS 6.5MM, 6MM, OR .223".

The LB is a perfect fit for barrels .750 - 1.0 inch in diameter at the muzzle. This brake is 1'' in diameter. Overall length is 2.225" and weighs 4.2 oz

aluminum construction

Weighs 8 ounces

Will fit any barrell from .750 up to 1.016 in diameter Must be bored to slip over barrel

aluminum construction

Weighs 8 ounces

Will fit any barrell from .750 up to 1.016 in diameter Must be bored to slip over barrel

The Gen 2 Series of brakes started where the Gen 1 left off. We came up with a solution for the shooter that has been a gamechanger. The Gen 2 has a nut that is a separate piece. This allows our customers to install the brake themselves at home. Installations take about 30 seconds and have no hideous crush washers or peel washers to deal with. Additionally, competitive shooters can easily remove this brake for cleaning or simply to move if from barrel to barrel. Competitors can burn through 6 barrels or more in a season at times. This means less money spent on gear and with your smith. To the gunsmith it means no hassle indexing a brake. Simply thread to spec and go.

This brake is meant for Larger barrels that are generally required by the 338 Lapua etc.

We recommend a barrel diameter of .850-1.0 inches for this brake. The diameter is 1.115" and cannot be turned down. Overall length is 3.3".

7.5 oz

The Gen 2 Series of brakes started where the Gen 1 left off. We came up with a solution for the shooter that has been a gamechanger. The Gen 2 has a nut that is a separate piece. This allows our customers to install the brake themselves at home. Installations take about 30 seconds and have no hideous crush washers or peel washers to deal with. Additionally, competitive shooters can easily remove this brake for cleaning or simply to move if from barrel to barrel. Competitors can burn through 6 barrels or more in a season at times. This means less money spent on gear and with your smith. To the gunsmith it means no hassle indexing a brake. Simply thread to spec and go.

This brake is meant for Larger barrels that are generally required by the 338 Lapua etc.

We recommend a barrel diameter of .850-1.0 inches for this brake. The diameter is 1.115" and cannot be turned down. Overall length is 3.3".

7.5 oz

Sostituisce le medesime parti originali. Il pomolo tattico garantisce presa migliore dell'orginale. La noce percussore (bolt shroud) sostituisce l'originale in materiale plastico soggetto a rotture.