Sinclair 30 Caliber Chamber Length Gage Cal. 308

HOME > RICARICA / RELOADING > ATTREZZATURA / RELOADING GEAR > STRUMENTI MISURA E CALIBRI >

IL NOSTRO PREZZO: €3.00

Stato del magazzino:PRODOTTO DISPONIBILE

CODICE ARTICOLO:: SIN749000804

QUANTITA':

Descrizione

insert pushes back into the case when it contacts the end of your chamber. You then extract the case and measure the overall length. The gauge is made of 12L14 soft steel so it will not damage your chamber. Step-by-step instructions accompany each gauge. The gauges can be used over and over again.

The differences between published trim lengths and the actual length of your chamber can be quite significant. You could be over trimming your cases by .030 inch or more.

NOTE: The 22 caliber gauge will not work on thin-necked cases such as the 22 Hornet, 218 Bee, or cartridges based on these cases. The 30 caliber gauge will not work on teh 30-30 Winchester. None of the gauges listed will work on tight-necked chambers except for the G-243T. Should not be used in handguns, semi automatic rifles, lever actions rifles and pump action rifles.

Condividi la tua conoscenza di questo prodotto. Sii il primo a scrivere una recensione »

	Sinclair 7mm Chamber Length Gage Cal. 284 €3.00
	TAB GEAR GREEN REAR BAG €47.00
	TAB GEAR MULTICAM REAR BAG €37.00
	Sinclair Trimmer Bracket - w/ Shark Fin Clamp Attachment €90.00